Florida has no mold law for gym saunas. Sign the petition for a mandate.

Sign the Petition

Vented Crawl Spaces: A Field Tour of the Four Failures Under the Floor

Energy Vanguard's Allison Bailes crawls a condo crawl space and catalogues the vented crawl space's four common problems — fiberglass batts falling out of the floor, moisture written in high-water stains on the block wall, bathtub-drain holes piping crawl-space air straight into the house, and uninsulated duct boots sweating at 55 to 60 degrees until the duct jacket holds gallons of water — in a space that runs 70 to 90 percent relative humidity all summer, past the 70 percent line where he notes mold growth takes off.

Setting: houses — the vented crawl space under the floor; the gym application is ours and is labelled as such. Source score: 8/10. This page is our original summary of a published building-science article. It is general information, not legal or medical advice.

Source: Energy Vanguard, “Vented Crawl Spaces: Some Common Problems” — by Allison Bailes, founder of Energy Vanguard, published March 29, 2010 and updated February 1, 2022. It completes this shelf’s Energy Vanguard crawl-space set: the three sources of crawl-space humidity named where the water comes from, and the two rules named the physics; this earliest piece is the field evidence — what the failures actually look like, photographed from inside the space.

The setting: a working crawl, not a theory

The article is a site visit. Serving on his condo association’s board, the author is asked to check a crawl space, straps on knee pads and a head lamp, and reports that after enough crawl spaces he rarely sees anything new — the problems repeat. That repetition is the article’s point: what follows is not one building’s bad luck but a catalogue, four failures he presents as common to the type, in no order of importance.

Problem 1 — the insulation leaves the floor

Fiberglass batt insulation installed between the floor joists is falling down — everywhere, in this space — batts hanging out of the floor assembly they were meant to insulate. A batt on the crawl-space floor insulates nothing: the floor above it is uninsulated in fact whatever the plans say, and (per the two-rules curation on this shelf) fiberglass batts do not separate humid air from cool surfaces in any case. The failure is mechanical first — gravity wins against friction-fit batts — and thermal second.

Problem 2 — moisture, with its own watermark

Soil is wet from below to begin with; openings that let outside water in make it worse. This space was not the worst he has seen — no standing water on the day — but the low side of the building had a dug-out perimeter area he calls pretty bad, and the red stains on the block wall record how high standing water has reached at other times. The wall keeps the flood’s diary whether anyone logs it or not. Read with the three-sources triage, this is source one (bulk water) and source two (ground evaporation) sharing a room: a dug-out low perimeter collects the first, and bare soil supplies the second continuously.

Problem 3 — the floor is a door

The third problem is the one that connects the crawl space to the people above it: a floor that lets the crawl space’s air into the house. His photograph shows the large holes cut for back-to-back bathtub drains and the smaller but still significant hole for the sewer pipe — unsealed penetrations, plumbing-sized, between the crawl space and the bathrooms above. His inventory of what that air carries is blunt — mold, animal waste, dead animals are, in his account, present in nearly every crawl space — and his question is the article’s sharpest: why cut holes that size to let that air straight into the living space? A vented crawl space is outside air by design; an unsealed floor makes the house breathe it.

Problem 4 — the boot that sweats gallons

No crawl space, he writes, is complete without ducts, and the fourth failure is the uninsulated supply boot — the sheet-metal piece connecting duct to register. The physics is the two rules in miniature: in summer this crawl space’s relative humidity runs 70 to 90 percent much of the time (he notes, in passing, that mold growth takes off at 70 percent relative humidity), and when cold air runs through the duct the boot’s metal drops to roughly 55 to 60 degrees — below the dew point most of the time — so condensation forms on the boot and drips into the fiberglass duct insulation. He has been in crawl spaces where so much water dripped into a duct that it hung there holding a couple of gallons of water in its insulation jacket. The duct becomes an accidental dehumidifier (the two-rules phrase) whose condensate is stored, not drained — inside the air-distribution system itself.

The verdict the article ends on

The good news, he writes, is that the problems are avoidable — and the fix is not a better vent. Building science research has shown that venting crawl spaces to the outside is not a good idea; he points readers to his page on crawl space encapsulation for the solution. That is the same destination the later articles reach from their other directions: the three-sources piece ends at encapsulation as the source fix, and the two-rules piece ends at separation or warm surfaces. This 2010 field tour is where the set starts: four photographs’ worth of reasons the vented box under the floor fails, before the theory that explains why.

Why it matters here — the gym application, in our words

The article is about houses. A gym is a building whose wettest rooms sit on floors, slabs, and subfloor voids its members never see — and every one of the four failures has a wet-room dialect. Falling batts are any underfloor or ceiling insulation that has left its assembly while the drawings still claim it. The watermark on the block wall is the stain line on a locker-room stud bay or a pool-equipment pit wall: water that visited and left no log entry except the one it wrote itself. The bathtub-drain holes are the founding geometry of this site — a sauna or shower room whose floor penetrations, drains, and bench fixings pipe the wet box’s air into wall cavities and neighbouring rooms, which is why our Zero-Mold Sauna Blueprint treats every penetration as a sealed, inspectable detail rather than a hole. And the sweating boot is any cold duct, pipe, or fitting crossing a steam room’s or shower suite’s humid air uninsulated: it will condense, it will drip, and if the drip lands in insulation it will be stored there, wet, in the dark, at exactly the humidity the article prints. When you file a report about a wet room, look under and behind as far as you safely can: what is below the floor, what holes connect the rooms, and what cold surface is sweating — the crawl space’s four failures, wearing gym clothes.

Tools for this job: Measure — moisture is the whole game

Pinless moisture meter

What it is: A handheld meter that reads moisture inside drywall, wood, and flooring through the surface — no pinholes, no damage. The tool that finds the wet wall behind the paint.

Why it is listed: Moisture readings are the hardest evidence to argue with. A dated photo of a meter reading on a wall turns a landlord dispute from opinion into documentation.

Its limits: Readings are relative and material-dependent — use them comparatively (wet spot vs. known-dry spot) and record both. A meter finds moisture, not mold.

Visit Pinless moisture meter →

Thermo-hygrometer / humidity data logger

What it is: A room thermometer-hygrometer; the logging kind records humidity over days and weeks instead of showing a single moment.

Why it is listed: A log beats a snapshot. Two weeks of humidity history above 60% is a document; a glance at a dial is an anecdote.

Its limits: Cheap sensors drift — sanity-check a new unit against a second one. Placement matters: measure where people live and sleep, not next to a shower door.

Visit Thermo-hygrometer / humidity data logger →

Some links in this strip are affiliate links and cost you nothing extra if you buy through one. As an Amazon Associate I earn from qualifying purchases. Affiliate money never buys scores, coverage, or silence — see our affiliate disclosure.

Read it at the source: Energy Vanguard — Vented Crawl Spaces: Some Common Problems.

If this happened to you

A gym wet room over a void you have never seen into — a shower bank that smells of the space below it, a sauna floor with unsealed penetrations? File a report with what the underside shows: stains that record old water, insulation out of place, holes between rooms, ducts or pipes sweating into insulation. The underside is evidence too, and it is the half of the building nobody photographs.

Not professional advice. This page summarizes one published article’s account for general information. Building-specific moisture assessment belongs to building professionals.

THE NETWORK — ONE PUBLISHER, EVERY FRONT

Published by Bowman Web Services.

DearDougCollins.comThe VA, on the record. SelfGrowthVideos.comThe teachers, distilled. AllegedFraud.comFraud in America — alleged, documented. RecoveryTourism.comTravel to recover. TrumpTeamReport.comThe administration, documented. RFKTeamReport.comThe MAHA team, on the record.